Skip to content

Troubleshooting

Common Issues

INITIALIZE_TOOLCHANGER - Tool Not Recognized

  • Check that you have the correct pin assigned to the OptoTap sensor.
  • If the tool initializes while off the shuttle, the logic is flipped. Either add or remove ! to the pin definition.
  • Some OptoTap sensors require a pullup to operate. Try adding a ^ to the pin definition.
  • Check wring/crimps.

INITIALIZE_TOOLCHANGER - Wrong Tool Recognized

  • Check the tool_number assignment in the [tool] section.

Wrong hotend fan turns on

  • Check the extruder assignment in the [heater_fan] section.

Wrong part fans turn on

  • Check the fan assignment in the [tool] section.

Wrong hotend heats up

  • Check the extruder assignment in the [tool] section.
  • Check the activate_gcode extruder in the [tool_probe] section.

Wrong extruder moves

  • Check the extruder assignment in the [tool] section.
  • Check the extruder name of the [tmc2209] section.

Community

StealthChanger has an active and growing community of people who are willing to help. If your having trouble finding the information you need. Consider reaching out to our communities on Discord or facebook and be sure to mention that your issue could not be resolved by the information here. We will do our best to accommodate the issue in the future.